This is a highly conductive polymer for use in a variety of applications and is an indispensable tool for fixing damaged circuit board tracks. Apply instant traces on most surfaces (epoxy, glass, plastic, metal).
Draw traces on circuit boards, repair defective traces, make jumpers and shield electronics, design prototype circuits and repair rear-window heater traces.
After heat curing only. Use low temperature soldering (less than 180oC/350oF) for not more than 5 seconds. Use low temperature soldering iron.
Product Specifications
- 1mm track trace width
- 0.02Ohm per mm resistivity
- Service Aid : Conductive Paint
- Physical state : Liquid Pen
- Chemical container type : Pen
- Length : 19.5 cm
- Width : 10 cm
- Height : 2 cm
